Of course for production, nothing beats a roll form tap with coolant through. Roll Forming Taps, Material Grade: Hss / M35, Size: 3-16 mm. These are always my tool of choice for a through hole, or when I can drill deep enough to allow a place for the chips to go forward. Long term tests (up to 150 days) have been carried out on steel specimens at temperatures between 5 and 90☌ in triply distilled water, solutions containing 35. I've busted far more expensive taps that I have cheap Greenfield split point taps. An apparatus is described for determining the corrosion behaviour of rotating ( 2 Hz) metal specimens in test solutions having a range of dissolved oxygen concentrations. I've used cheap taps, and expensive taps. The horsepower requirements are not that great either. Applicable Workpiece: suitable for low carbon steel, medium carbon steel, high carbon. For giggles and grins, crank it up to 10 or 20 times that value and actually time the cycle from the start to the retract and you'll not see much difference. A point tap has a similar shape to a straight tap but provides smoother chip evacuation for through. 'M2 taping in mild steel' is hardly enough information to allow anybody to give advice to you. cast iron, medium carbon steel, and non ferrous metal. Having said that, some controls don't allow you to split the decimal point for rigid tapping so I typically choose something conservative close to 30 SFM in steel.įor a 1/2" tap I would use a feed rate of 30 IPM which means you want an RPM of 390. Comments Format: Indented / nested by replies Flat / chronological Save setting as my default. I seriously doubt any machine is going to come near the rated value you set starting from zero and then having to hit 0 before retracting at any rate. While I often tap aluminum at 1000RPM or even 6000 RPM in the Mazak, that's all a crock anyway. The first place you need to start is the manufacturers recommended RPM.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |